This is a kit I offer. Look at my other listings if you only need the Puller Tool Only.
Puller tool for Harley Davidson CV Carburetor with tap and fuel inlet fitting.
If your black Plastic fitting has not cracked off it will in time.
You will also need two 7/16" Wrenches and Tap Holder.

#1 REMOVE ANY BLACK PLASTIC REMAINING
#2 TAP HOLE IT IS BEST TO PACK THE HOLE WITH PAPER TOWEL SO CHIPS WILL NOT FALL IN. DON'T GO PAST END OF BRASS FITTING.
#3 INSTALL TOOL
#4 TURN LOWER NUT AND HOLD TOP NUT STILL.
#5 CLEAN AND INSTALL NEW ALL BRASS FITTING.
FAST FREE SHIPPING!!!!