50' 2-2-4 Aluminum SEU Service Entrance Cable PVC Jacket Gray 600V

Click Thumbnails to Enlarge

APPLICATION

2-2-4 Aluminum SEU Service Entrance Cable Primarily used to convey power from the service drop to the meter base and from the meter base to the distribution panel board. SEU can also be used in certain branch circuits as permitted by the 2005 National Electric Code. Maximum operating temperature is not to exceed 90°C in wet or dry locations. Voltage rating is 600 volts.

CONDUCTOR

- Compact Strand Soft drawn 8000 Series Aluminum Conductor, per ASTM B-801

INSULATION

- Type XHHW-2 cross-linked polyethylene (XLP) insulation.
- The conductors are cabled together with an aluminum alloy concentric neutral and covered with a reinforced binder tape.

JACKET

- Gray Sunlight Resistance Polyvinyl Chloride (PVC) Jacket.

CABLING

- Two insulated conductors are laid in parallel and bare neutral wires are applied concentrically over the insulated conductors. A binding tape is applied over the neutral wires.

STANDARDS

- 60°C When Terminated to equipment for circuits rated 100 amps or less or marked for 14 AWG through 1 AWG conductors
- 70°C When Terminated to equipment for circuits rated over 100 Amps or marked for conductors larger than 1 AWG 90°C wet or dry locations
- For dwelling units, conductors shall be permitted at listed Ampacities to be utilized as 120/240 volt, 3-wire, single phase service conductors that supply the total load

DISCLAIMER

- Picture May Not Represent Actual Cable and Is Only Used As A Representation Please Refer to The Specifications For Product Accuracy.

PRODUCT SPECIFICATIONS