Skoda Fabia VRS MK1 Boost Gauge Mount/Pod for 52mm/2" Gauges.

Gauge is angled towards driver for better visibility.

Replaces fins of stock center console vent. Uses stock mounts, no need for screws etc, simply slots into place.

Gauges longer than 45mm: some trimming of the vent duct (not the visible face, the internal vent duct) may be required in order for the gauge to fit correctly if you have a particularly long gauge (tested with 45mm long gauge with no need for trimming, just a firm push to get the gauge into place).

TO FIT RIGHT HAND DRIVE VEHICLE, CONTACT SELLER FOR LEFT HAND DRIVE VERSION:
The gauge is angled slightly towards the driver for right hand drive vehicles, if your vehicle is left hand drive please contact me before purchasing so we can supply you with a left hand drive version. 

This part is 3D printed, and as such does have visible "layer lines" rather than a perfect surface finish (as seen in the images above). These lines can be easily sanded smooth, or covered over with filler primer and spray paint for a nicer surface finish.

Installation instructions:

  1. Remove vent assembly.
  2. Separate vent duct from vent trim
  3. Remove fins from vent duct
  4. Install Gauge into mount
  5. Slot gauge mount onto vent duct
  6. Re-attach vent duct to vent trim
    6.1. You may want to take the opportunity to run hoses and cables while the vent is removed.
  7. Replace vent assembly
GAUGE AND VENT ASSEMBLY NOT INCLUDED. THIS LISTING IS FOR GAUGE MOUNT ONLY.