VW Golf Bora MKIV MK4 VENTED Driver Window Vent Gauge Mount Pod Boost 52mm 2"

To fit 52mm/2" gauges only.

Fits MK4 (1997-2003) 1J1 Golf models, and 1J2 & 1J6(estate) (1999-2006) Bora models

THIS ITEM ONLY FITS TILT-STYLE VENTS, NOT FLUSH-STYLE. PLEASE COMPARE TO THE VENTS IN THE ITEM PHOTOS. TILT-STYLE VENTS ONLY HAVE ONE CONTROL WHEEL.

Gauge is angled towards driver for better visibility.

Replaces vent grille of stock driver side vent. Uses stock mounts, no need for screws etc, simply slots into place.

See my other items for non-vented version and centre-console vent versions

Some trimming of the vent duct (not the visible face, the internal vent duct) may be required in order for the gauge to fit correctly.

TO FIT RIGHT HAND DRIVE VEHICLE, CONTACT SELLER FOR LEFT HAND DRIVE VERSION:
The gauge is angled slightly towards the driver for right hand drive vehicles, if your vehicle is left hand drive please contact before purchasing so we can supply you with a left hand drive version. 

This part is 3D printed, and as such does have visible "layer lines" rather than a perfect surface finish (as seen in the images). These lines can be easily sanded smooth, or covered over with filler primer and spray paint for a nicer surface finish.

Installation instructions:

  1. Remove vent assembly from dashboard (this is optional, but will make later steps much easier)
  2. Remove vent grille
  3. Insert included clips into the pivot holes on either side of the vent duct (see images)
  4. Slot gauge mount onto clips
  5. Replace vent assembly in dashboard (you may want to take the opportunity to run hoses and wires while vent is removed)
  6. Install gauge

GAUGE AND VENT ASSEMBLY NOT INCLUDED. THIS LISTING IS FOR GAUGE MOUNT ONLY.