Notes

1 When the lamp is plugged into the controller, find the socket corresponding to the serial number

 

2 The sensing distance between the sensor and the light-emitting board is about 2 meters, and it needs to be aligned and installed on the same horizontal line, otherwise it cannot be sensed

 

3 Be sure to connect the positive and negative poles, red positive and black negative. Low voltage connects to 12-24V, not to AC 220V.

 

4 You can reserve the wire slot position for wiring first, and connect the positive and negative poles of the sensor and the light wire accordingly

 

5 Sensors: one at the head of the stairs and one at the end of the stairs

 

Function

 

1 Long press to set 1 indicator light flashes red, then press to set

1 to adjust the speed from 1-5 (speed 1 is the slowest, speed 5 is the fastest)

 

2 Long press to set 1 indicator light flashes red light to stop flashing red light, adjustable 1-5 delays (no one delay +10 seconds, the first delay is 10 seconds, the second delay is 20 seconds)

 

3 Long press to set 2 the indicator light flashes red, then press to set 1 to set the number of stair steps (press to set 1 to increase the number of steps, and to set 2 to decrease the number of steps)

 

4 When the light is on, press Set 2 to adjust the brightness from 1-5 levels (1 level is the darkest and 5 levels are the brightest)