• 4 x  Nema23 112mm stepper motor (Dual Shaft),425oz-in,3A  
• 4 x CW5045 Stepper Motor driver 50V,4.5A,256 high microstep
• 1 x 400W 36V/11A switching power supply
• 1 x 5 axis breakout board V5 type
• 1 x DB25 parallel cable
• 1 x USB cable
• English user manual for breakout board and stepper motor driver will send by email.

4 Axis for medium size Router Mill Plasma or Laser

I.  5 axis breakout board

• It can most connection 5pcs driver and control 5pcs motor in the same time
• It is with 4-wire limit switch to insure our safty movement
• It is with relay port to contro the cnc spindle
• Working voltage is 5VDC and support with MACH3,EMC2,KCAM4 software
• Size:9x5.7cm

II.  CW5045 high microstep stepper motor driver

• DC power input type:24V~50VDC ;
• Output current:1.3A-4.5A ;
• Mircostepping:1(1.8º) 1/2,1/4,1/8,1/16,1/32,1/64,1/128,1/256; 1/5,1/10,1/25,1/50,1/125,1/250  ;
• Protect form : Overheated  protect, lock automatic half current ,error connect protect ;
• Working environment:Temperature-15-40deg  Humidity<90% ;
• It is fit for NEMA17-23 two and four phase stepper motors whose current is small than 4.5A,it also can fit for small length NEMA34 two and four phase stepper motors.

III. Stepper Motor

General Specification:

Step angle accuracy:+ -  5%(full step,not load)

Resistance accuracy: + - 10%

Inductance accuracy:+ - 20%

Temperature rise: 80deg Max(rated current,2 phase on)

Ambient temperature ----------—20deg  ----  +50deg

Insulation resistance:100ohm  Min,500VDC

Insultion Strength--------500VAC for one minute

Datasheet(23HS2430B,Front shaft 8mm dia and 21mm length;back shaft 8mm dia and 11mm length,425 oz-in or 28kg.cm holding torque)

 Note:if you need single shaft pls contact us,we have in stock.

Motor lead wires:

Red:       A+

Green:   A-

Yellow:   B+

Blue:      B-

IV.Switching power supply

400W,Input:100-120VAC or 200-240VAC,50/60Hz,Output:36v/9.7 A,single output switching power supply.