Important note:
The positive and negative terminals of the power supply input of the
controller cannot be reversed, the red wire V+ is connected to the
positive electrode of the switching power supply, and the blue (or black
wire) V- is connected to the negative electrode of the switching power
supply.
controller cannot be reversed, the red wire V+ is connected to the
positive electrode of the switching power supply, and the blue (or black
wire) V- is connected to the negative electrode of the switching power
supply.
Product packaging LED Controller set include:
1 *LED Controller
2 * Motion Sensors
Note: 1-you need buy the Power supply & white strip lights and addressable strip lights
2-The sensor has been changed to white.
Product description:
multi-function LED controller with two sensors, which can
drive 2 kinds of LED lights, one is a dreamcolor light that supports a
universal SPI single-wire chip, such as the universal 1903, 1909, 1912,
TM1812, WS2811, 16703, WS2812B, 8205, 8206 and so on full-color pixel
LED lights, the control system at the lower left corner of DO1, GND,
DO2, GND with 2 parallel output terminals, can be connected to the left
and right sides of the stairs lights. The output terminals on both sides
of the controller are for the rgb light strips used on the
stair tread, the number of light strips can be adjusted. The
function setting of the induction controller is selected by the buttons.
The setting is displayed through the 4-digit digital tubes on the left.
drive 2 kinds of LED lights, one is a dreamcolor light that supports a
universal SPI single-wire chip, such as the universal 1903, 1909, 1912,
TM1812, WS2811, 16703, WS2812B, 8205, 8206 and so on full-color pixel
LED lights, the control system at the lower left corner of DO1, GND,
DO2, GND with 2 parallel output terminals, can be connected to the left
and right sides of the stairs lights. The output terminals on both sides
of the controller are for the rgb light strips used on the
stair tread, the number of light strips can be adjusted. The
function setting of the induction controller is selected by the buttons.
The setting is displayed through the 4-digit digital tubes on the left.
Connection guide
Please connect the controller and motion sensor according to the drawing:
