E-bike SW900 LCD Display Control Panel Electric Bicycle Speed Meter Speedometer

Specifications:

  • Name: Speed Meter
  • [Model] SL-SW900YB
  • [Material]_ ABS+LCD liquid crystal instrument
  • [Voltage]_ 24V/36V/48V/52V/60V
  • [Specification]. As shown in the figure below (the line length is about 2 meters)
  • [Weight]_235G
  • [Packaging] Bubble bag
  • Color: Black (As picture show)
    Material: ABS + LCD
  • Voltage: 24V, 36V, 48V, 52V, 60V
  • Plug: Waterproof Plug
  • Mode: SL-SW900YB
  • Application: E-Bike Motor Conversion Kit

Features:

  • (1) Display Function:
    Speed display, power-assisted gear display, power indicator, fault prompt, total mileage, single mileage, headlights and single driving time display.
  • (2) Control/Setting Function:
    Power switch control, headlight switch control, 6Km/h boost control, wheel diameter setting, speed limit setting, meter sleep setting, backlight brightness setting, voltage setting.
  • (3) Harness Description:
    Red (P+) meter power cord
    Blue (VCC) electric door lock wire
    Black (GND) negative wire
    Green (RX) Meter data receiving
    Yellow (TX) Meter data transmission
  • (4) Meter Setting Function:
    ①Long press the up and down buttons of the meter to enter the meter settings.
    P01: Backlight brightness, level 1 is the darkest, level 3 is the brightest.
    P02: Mileage unit, 0: KM; 1: MILE.
    P03: Voltage level: 24V, 36V, 48V.
    P04: Sleep time: 0, no sleep; other numbers are sleep time, range: 1-60; unit minutes.
    P05: Power assist gear 1-9
    P06: Wheel diameter: unit, inch; precision: 0.1.
    P07: Number of speed magnets: range: 1-100.
    P08: Speed limit: speed percentage range 0-100%, 100 means speed 100%.
    P09: Zero start, non-zero start setting, 0: zero start; 1: non-zero start.
    P10: Drive mode setting 0: power-assisted drive (the handle is invalid).
    1: Electric drive (by turning the handle to drive, the power gear is invalid at this time).
    2: Power-assisted drive and electric drive coexist at the same time.
    P11: Assist sensitivity setting range: 1-24.
    P12: Assist start intensity setting range: 0-5.
    P13: Power-assisted magnet type setting There are three types of 5, 8, and 12 magnets, of which 5 and 8 are single Hall power-assisted sensors.
    ②Setting 12 is used for dual Hall assist sensors.
    P14: This function is not available yet.
    P15: This function is not available yet.
    P16: ODO reset setting, Long press the up button for 5 seconds ODO reset

Packing list:

  • 1 x Speed Meter

Note:

  • Light shooting and different displays may cause the color of the item in the picture a little different from the real thing.
  • Manual measuring,please allow 1~3mm error,thank you.
PushAuction


On Aug 31, 2023 at 02:01:25 PDT, seller added the following information:

DataCaciques