1- Premium quality CNC machined brass gear.
1- OEM quality rubber bumper gear insert.
1- Thrust washer/spacer.
1- Tube of easy to apply super-fast drying glue that is much stronger than the messy two-part epoxy sold by some.
1- T-brace kit with plastic output shaft bearing (This bolts on with the motor to Re-enforce the glued-on side cover).
1- Easy to apply blister packs of synthetic gear grease (with Teflon) that won't melt and foul the brushes.
1- Rubber band to hold side cover as glue dries. not shown (temporary use).
1- Hard copy of detailed instructions specific to 1993-2002 Pontiac Firebird/Trans Am
SYMTOMS OF GEAR FAILURE:
1. The headlight motor runs for several seconds but does not open the headlight.
2. The headlight only opens partially or droops after it has opened.
3. The headlight opens and closes but the motor continues to run with a loud grinding noise.
Most headlight motors fail because of the plastic gears that GM put in these motors. The electrical part of the motor typically does not fail. I have also seen a lot of gear failures with the cheap undersized aftermarket plastic gears sold by others.
Unlike other low-quality plastic and brass kits, this kit contains all of the parts and lubricants needed to do it right the first time! This brass gear kit will last the lifetime of your car so you will never need to rebuild again due to a bad gear. This heavy-duty brass gear will never break or sheer teeth like the OEM plastic gears, and even lower quality aftermarket plastic gears being sold, and they will not bind up your motor like some of the low-quality brass and aluminum gears sold by others.