eBay

Beware of imitations: other fans may look identical but might not offer the same quality.

Universal Dirt bike motorbike fan kit.

Kit contains :

12v High velocity fan ( Airflow 220 m3/h )
Inline fuse
Aluminium Brackets and hardware
80/90 degree temp switch
( depends where you mount it to how soon it reaches / decreases temperature activates / shuts off the fan )
ON/OFF switch
80cm of electrical wire.
Wiring diagram / instructions

Benefits:

Keep your bike from overheating / Boiling during slow technical riding or any tricky situation.
No cutting and joining of factory radiator hoses needed to install the temperature sensor like other kits offered.
Maintain an optimum operating temperature.
No waiting for your bike to cool down before continuing your ride.
Maximum air flow to avoid causing your engine any harm.
Only draws 15 watts when running.

Since this is a UNIVERSAL Fit a small amount of wiring will be required, if you are not confident with this please message me as i can

make up a full wiring harness with plugs up per order at additional cost.

IF YOU WANT ME TO BUILD YOU A BIKE SPECIFIC KIT SEND ME A MESSAGE PRIOR TO PURCHASING !

FOR A PRE-MADE WIRING HARNESS

 Click here to view!

IF YOU WANT A TPI KIT

 Click here to view!

Typical dirt bike cooling system has been designed with the expectation of constant airflow to maintain an optimum operating temperature.

This kit is perfect for most dirt bike riders who want a quality thermo fan but without breaking the bank , these will automatically turn on and off when your bike reaches the 80 / 90 degree range so no need to monitor it yourself, or these can be easily ran to a manual on/off switch.

We have been running this fan on our bikes for the past 4 years and over 600 hard hours with zero issues, the fan itself is good quality and waterproof so no issues with washing rain mud ect ,unlike some cheap fans offered on ebay !

These fans should fit most makes and models just check measurements before purchasing.
The Fan Size is 47mm Deep and 120mm Wide

Brackets Should suit most radiators that are around 120mm Wide, you can use the Bolts or Rivets to fix Brackets into place.

PLEASE CHECK BEFORE PURCHASING

Installation :

If you would like these installed on your bike, please contact me before purchasing for pricing ect ,as i am now offering this service.

located in Gippsland Vic 3844

Once again Thank you everyone for supporting a small business it is much appreciated :)

Disclaimer:

All these Thermo fans / parts are tested before being sent out, if any damage is incurred during installation or from Australia post i accept no responsibility for this, but i am willing to try my best to resolve any issues.

I'm sure you can understand =)