100% brand new and high quality

Made of high-quality materials, durable

The DRV8825 stepper motor driver carrier is the breakout board for TI's DRV8825 microstepping bipolar stepper motor driver.

This module has almost the same pins and interfaces as our A4988 stepper motor driver carrier, so it can be used as a higher performance direct replacement for these boards in many applications

DRV8825 has adjustable current limit, overcurrent and overheat protection, and six microstep resolutions (down to 1/32 step)

Its operating voltage is 8.2 – 45 V, and each phase can provide up to approximately 1.5 A of current without the need for a radiator or forced air (the rated current of each coil is up to 2.2 A, and there is sufficient additional cooling)

Simple step and direction control interface

Six different step resolutions: full step, half step, 1/4 step, 1/8 step, 1/16 step and 1/32 step

Can directly interface with 3.3V and 5V systems

Over-temperature thermal shutdown, over-current shutdown and under-voltage lockout

Short-to-ground and load short-circuit protection

4-layer 2 oz copper PCB for improved heat dissipation

Exposed solderable ground pad under the driver IC on the bottom of the PCB

The module size, pinout and interface match our A4988 stepper motor driver carrier in most aspects

Adjustable current control allows you to use the potentiometer to set the maximum current output, allowing you to use a voltage higher than the rated voltage of the stepper motor to achieve a higher step rate

Intelligent chopper control, automatically select the correct current attenuation mode (fast decay or slow decay)

45 V maximum supply voltage

Built-in voltage regulator (no need for external logic voltage supply)

5 *DRV8825 stepper motor driver

5 *Radiator