![](https://www.kittom.com/gitto/images/gt_spc.jpg)
- Condition: 100% new
- Color: White
- Material: Plastic & Metal
- Size: As pictures show
- Working Volt: 9-32V
- Operating Current: 100mA(24V)
- Operating Temperature: -30~+75
- Storage Temperature: -40~+85
- Range: PORT-STBD
- Signal: 0-190 Ohms
- Item included:
1 x rudder angle indicator
1 x cable
1 x user manual
- Suitable for: engines / generator, engineering machinery, agricultural machinery, automotive modification, etc.
-
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
![](https://www.kittom.com/gitto/images/gt_des.jpg)
Product Dimension:
Feature:
1) According to the original factory specifications.
2) 316L stainless steel for long-term use even in acid-base, humid environment.
3) IP67 waterproof and dustproof grade.
4) Stepper motors used for full range of stepping gauges, great feature with its less power consumption, longer life, higher precision.
5) With curved glass (with anti-fog function).
6) With ultra-wide working voltage design (long-term operating voltage: 9-32V.
7) Maximum up to: 36V ( 1 minute).
8) Gauge with multi-color LED light of back-lit illumination (red, yellow, green, blue, purple, white), can be customized according to customer's requirements.
Backlight Color Adjustment:
1) Press the Set button (less than 1 second) to change the backlight color: Backlight changed in sequence: red (default) green blue white yellow yellow green orange Purple (automatic).
2) Automatic: As the gauges was set with the automatic, the backlight will be off for 2 seconds then lighten up, and will switch the backlight color as above sequence.
3) Users could select the input resistance as down below operations if you have Fuel /Water/Sewage level gauge. Hold the Mode button for 3 seconds to enter the setting mode, back light flickering for a while. The needle point at the E position, and you could select the corresponding parameter via pressing the button as down below form.
![](https://www.kittom.com/gitto/images/gt_boat_hmain.jpg)