Home industry dual-purpose electric iron, miniature electric heating pressure steam boiler iron, electric iron with boiler

Model: ST-75
Boiler power: 1600w
Iron power: 900w
Water tank capacity: 2L
Size: 480*305*390mm
Voltage: 220V/110V
Power: 2500W
Manual: Chinese and English




1. Open the safety valve, add water with a funnel, add 2000ml of water for the 75 type to the 2.0 position of the measuring tube.
Note: Exceeding the water level may easily cause water out of the iron (because the water is too full, the steam will spray out with water if there is no place to store it), then tighten the safety valve.
2. Plug in the power supply, turn on the boiler heating switch and the iron heating switch, and enter the heating state. When the air pressure reaches 0.35-0.4, the green light is on, indicating that the heating is completed.
3. When operating the above steps, you can turn on the power switch of the iron and adjust the temperature knob between 3-4. The steam temperature is about 150 degrees Celsius, which is suitable for most fabrics. If you have special needs, you can set the iron temperature by yourself (1 low-5 high) in four or five minutes.
4. Press the steam switch of the iron to have powerful steam, which can be continuously sprayed. If you feel that the sprayed air pressure is too large or too small, you can adjust the solenoid valve steam size knob (clockwise small, counterclockwise large), if you do not need to open the steam The iron switch can be dry ironed. After use, turn off the boiler heating switch and the iron heating switch.
5. The machine generally does not need to be drained. If it is necessary to drain, open the safety valve and gently tilt the direction of the safety valve to drain the water. Please do not turn the machine upside down and shake the machine violently.
6. This machine is equipped with anti-dry-burning device, but you should try to avoid rabbits from dry-burning. When you use it for the first time, check the time when the water is used up, and add water earlier next time.