- Ensure the hair is 80% dry and combed through to remove any tangles. Divide the hair into sections ready for styling.
- Slide the switch to the heat setting suitable for your hair type to turn the appliance on. Please note: The blue LED light will illuminate to indicate the ionic feature is activated.
- Place the brush underneath the hair section, close to the scalp and hold for a few seconds to boost volume at the roots.
- Use the brush to lift the hair at the roots as you dry.
- Move the appliance down through the hair and start to rotate the brush away from your head by pressing and holding the appropriate rotation button.
- As you do this, resist the rotation of the brush by pulling the brush downwards. This will create tension through the section of hair.
IMPORTANT!
- It may take several attempts to perfect this technique, if the brush spins too quickly, simply release the rotation button and remove from the hair.
- As you reach the ends of the hair section, continue rotating the brush to roll the ends under.
- For even more volume, place the brush at the end of the hair section and allow the brush to rotate along the hair section by pressing and holding the appropriate rotate button. Wind the entire section of hair around the barrel until you reach the root. Release the rotate button and then hold the brush in the hair for a few seconds.
- Repeat for each section of hair.
- After use, slide the switch to the ‘0’ position to switch off and unplug the appliance.
- Allow the appliance to cool before storing away.
- Place protective cover over the brush head to protect the bristles. (See ‘Protective Cover’ section for more information).
Heat Settings
- There are 2 heat settings plus a cool setting. Use the cool setting on warm hair to set your style. Slide the switch to the ‘*’ position to select the cool setting, the ‘I’ position to select the low heat, and the ‘II’ position to select the high heat. If you have delicate, fine bleached or coloured hair, use the lower heat setting. For thicker hair, use the higher heat setting.
- Rotation Settings
- To make the brush head rotate, press and hold the buttons marked <>. This will make the brush head rotate clockwise and anti[1]clockwise.
Protective Cover
After each use, always ensure the protective cover is placed over the brush head. This protects the bristles from damage. When placing the protective cover over the brush head, ensure the grooves line up with the top of the airstyler so it slides easily into place. Please note: The diagram on the protective cover demonstrates the direction it should be places onto the brush head. If placed incorrectly it may be difficult to remove.