Custom LED graphic display upgrade.
Configured specifically for the Tascam DM-24.
Black/White Blue/White graphics available.

Tascam state on their website, NO replacement display is available for the DM-24.
This is not true, any longer.
A modern LED replacement is now available here.
This new LED display is the only way to properly upgrade your DM-24. Additional work is required to the display to allow Plug N Play installation in the DM-24, as a result the price is slightly higher than the 3200/4800 display (listed separately)

The end result is an LED display that's easy to install. Installation can be completed in less than 1 hour.
The DM-24 in the pics is one ive upgraded personally. Its a big heavy brute, however, when handled correctly with common sense, the display can be swapped quite easily.
Illustrated instructions will be supplied.
Its NOT necessary to take the mixer to a service centre to install the display. The only skill required is the ability to use a screwdriver. The only cost, should be the purchase of the display.
No additional charges !
No service centre fees !
NO soldering is required !

This display has a modern LED backlight, a huge improvement over the ccfl (Cold Cathode Fluorescent Lamp) found inside your DM-24.
You should judge this display as an upgrade not simply a replacement.
The original ribbon used to connect the old display, connects to the LED display in the same way, this is important as it simplifies the whole install process.
This is possible because the correct RA LIF connector is attached to the display before it ships.
The pitch of the LIF connector on the new graphic matches the pitch of the FFC ribbon on the DM-24.
To connect up, you will simply, disconnect the ribbon from the old display, reconnect it to the new display. Finally, connect up the backlight, this is also on a connector leaving it plug N play as well. I'll provide you with visual instructions of a new display connected up for ref.
The backlight connections and circuits to fine tune the contrast are also incorporated within.
The listing price includes the display and all the work to leave it Plug N Play !

This custom made display is in a different league completely to the old ccfl one inside your mixer.
Most importantly, it has an LED backlight that runs completely cool. The display problems, associated with these mixers, is a direct result of the inferior quality of the old display construction and the limited lifespan of the ccfl backlight (15-20k hours) 
Once the old display is removed / replaced with an LED backlight, the display performance is improved. Backlight performance increases 5 fold to a typical (100k hours) for an LED. Therefore, display lifespan of 15-20+ years, should be expected, once installed in your mixer. Not the 1-2 year typical with the ccfl type. Its simple, fit this NEW LED display and your problems are over. For a very long time. Guaranteed.

**THIS DISPLAY CANNOT BE INSTALLED WITHOUT MY SUPERVISION. CONTACT ME FOR DETAILED STEP BY STEP INSTRUCTIONS BEFORE ATTEMPTING TO INSTALL**

**The LED backlight is smaller, more compact than the old CCFL one found on the old display. Also, the LED backlight is powered differently, that means it "connects" Plug N Play differently. You will ASK for instructions how to do this,  when your ready to install. Thats the best time to discuss things**

**This display is configured specifically for the DM-24. It will NOT Plug N Play in a DM-3200 or DM-4800. A custom built display is available for the 3200/4800. Listed separately**