A New Turb Lighter Gas Welding Gun Cigarette Torch Box Holds  Cigarettes 

To dear buyers:



Due to international shipping safety regulations, gasoline is not allowed to be shipped. So we don't put gasoline in the lighter. 
You need to add gasoline yourself.

Tips:

!!! reminder!!! Because this product is equipped with a spring device, for safety, please do not place the product (where it will cause bumps and shakes) to avoid natural ignition of the product. Please use it carefully, thank you!

► Due to the transportation safety regulations, the products you buy do not have natural gas, so you need to buy natural gas (or add kerosene) by yourself

1. If it contains pressurized flammable gas, please keep away from children;

2. Do not puncture or discard the lighter or throw it into the fire;

3. Please use in a ventilated environment and pay attention to flammable materials;

4. Flammable substances such as face, skin and clothes are prohibited from entering the fire direction to avoid danger;

5. When igniting, please confirm the position of the fire outlet and press the ignition switch correctly. Different types of lighters use different ignition methods;

6. When using, if the soot and other sundries fall into the fire outlet accidentally, purge and remove the sundries in time, otherwise it will lead to poor ignition;

7. If the engine cover of loudspeaker, grinding wheel and gasoline lighter is opened, the gas begins to escape. Therefore, when the ignition switch is not started, the machine must be tightly covered for storage;

8. This product is not applicable to lighting. Please do not burn for more than 1 minute to avoid scalding skin;

9. Do not place the lighter in high temperature environment (50 ° C/122 ° F) for a long time, and avoid direct sunlight for a long time, such as enclosed unmanned vehicles and luggage around the stove and outdoors;

10. Due to the limitation of the climate above 3000 meters on combustion conditions, the ignition performance of windproof and direct impact lighters will be greatly affected. It is recommended to use an open flame lighter at this time;

11. When using desktop and other manual lighters, the positions of seven outlets, compressors, air inlets and flame regulators should be clearly specified to ensure correct use;

12. Qualified butane gas shall be used. Bad gas may damage the lighter or shorten its service life.

Adjust the flame

1. In the process of use, the flame height will change to a certain extent with the reduction of product gas content and the change of ambient temperature. This is normal. You can adjust the flame height appropriately;

2. During use, the normal flame height should be adjusted to:

The windproof and direct impact lighter is 1.5-2.5cm; 2.5-4.0cm, suitable for loud, gasoline and open flame lighters;

3. If it is necessary to adjust the flame height, use a slotted screwdriver to align the groove of the flame regulator; If the lighter itself is equipped with an adjusting ring, you can directly adjust it to the clockwise (-) arrow with your finger to reduce the flame height;

Turn counterclockwise in the direction of the (+) arrow to increase the flame height.

4. The flame height of gasoline lighter shall be controlled by adjusting the height of ignition core. If the flame height is too high, cut a little wick with scissors;

If the flame height is too low, pull out the wick correctly.

Gas filling method

1. When inflating, there shall be no spark or kindling around to ensure safety. Do not add gas when smoking;

2. Qualified butane gas shall be used. Bad gas may damage the lighter or shorten its service life;

3. When inflating the ordinary model, put the lighter upside down, align it with the cylinder and cover the air inlet of the lighter, and press hard for several times, each time for about 2 seconds; If gas cannot be filled, excess air may remain in the gas tank. At this time, it can be deflated vertically. At this time, use a small screwdriver to aim at the air inlet, quickly deflate 1-2 times, and then invert for inflation;

4. When refuelling with gasoline, open the top cover, pull it out and move it in the opposite direction, lift the outer sponge and add a proper amount of gasoline. After gasoline seeps into the inner cotton, cover the outer sponge and put it into the shell;

5. After replenishing fuel for various lighters, wait for at least one minute, adjust the temperature of the new filling gas to room temperature, and ignite after the residual gas attached to the surface of the lighter is completely volatilized. If the ignition operation is carried out immediately at this time, the residual gas on the surface of the lighter may be ignited, causing unnecessary danger. After gas supplement, if the flame height is too high or too low during use, it is normal, and the flame height can be adjusted appropriately.