When you receive your vinyl, there is a front and a back. The front side is the shiny side - that shiny layer is the carrier sheet which you can peel off after you've ironed your project. The backside is the matte side that has the heat-activated adhesive.

You can pretty much iron on anything that won't melt! ,Custom T-shirt, Sweatshirts, Polo Shirts,  The transfer works best on cotton or polyester or cotton/poly blends.

NOT SUITABLE FOR very stretchy materials, synthetic fabrics, nylon, leather, satin, lace, wool, etc

I accept no responsibility for any damage to your garment, If you are unsure if damage will occur please check the clothing label before ironing.

STEP 1. Set your iron to the cotton/linen setting. Make sure the steam setting is OFF for steam irons.

STEP 2. Use the iron to pre-heat the area of the material in which you will be applying your transfer to remove wrinkles for 10 to 15 seconds.

STEP 3. Place the transfer, plastic side up, onto the preheated material. To protect the transfer from excessive heat, please iron using a parchment or greaseproof paper 

STEP 4. Press down on your iron and apply pressure to each part of the design. Move the iron up and down, left to right, to ensure all areas have been firmly pressed for 15-20 seconds. DO NOT SLIDE IRON!

STEP 5. Let cool 5-10 seconds. Remove plastic slowly from one corner, if the transfer does not adhere to the material repeat steps 3, 4 and 5. The transfer must melt in the material.

STEP 6. Once you have removed the clear carrier plastic sheet place the parchment paper over the top of the transfer and press for a further 10-15 seconds to fix the transfer.

DO NOT WASH  GARMENT FOR AT LEAST 24 HOURS. When washing turn inside out and wash no hotter than a 40 degree wash

Instructions are included with every purchase,