ModuleMe Electronic

Features:
1.No contact, as it is not in contact with the suspension, there is no friction, no mechanical wear, low energy consumption, and low noise
2.It does not require supporting media and can be applied under various special conditions such as vacuum, ultra clean, high temperature, and low temperature
3.The force distribution is uniform, so the magnetic levitation support force is evenly distributed throughout the entire magnetic pole surface, greatly reducing stress and improving service life reliability
4.Long term operation without lubrication and maintenance
5.Suitable for students or DIY electronics enthusiasts to learn pull-up maglev

Parameter:
Product name: pull-up maglev
Power supply voltage: 12V 1A-2A
Power consumption: 2-10W
After production, the product size is approximately 6.5CM long * 6.5CM wide * 10CM high
Composition: composed of analog circuit and Hall sensor
The maximum suspended weight is about 50 grams
How to place suspended solids
1. Connect the power supply first.
2. Hold the magnet and slowly approach the coil from bottom to top. When the distance is about 2 centimeters, you can feel the suction provided by the coil. Once it stabilizes, let go.
If the magnetic force is not enough, you can adjust the blue potentiometer on the board for debugging, increasing the magnetic force clockwise and decreasing it counterclockwise,
Adjust the magnetic force to the optimal position, otherwise it will shake.

Matters needing attention
1.Do not let the magnet adhere to the coil when powered on, as it can easily damage the device.
2.Failure to discharge the float for a long time can cause an increase in the temperature of the transistor and coil. It is recommended to unplug the power supply and try again after 5 unsuccessful discharge attempts.
3.Keep magnets away from other electronic products, such as mobile phones, bank cards, etc.
4.Long term load requires an additional fan, otherwise the increase in coil temperature will affect the normal operation of the sensor.
5.The float uses a magnet to attract a 2032 battery, with an LED welded to it, making it feel like a small sun floating in the air. (Shipped without battery)

Package include:
DIY kit * 1