These Apico Factory Bling Packs are now available for a wide selection of Japanese & European dirt bikes

They are a very easy & cost effective way to buy a large selection of colour anodised, CNC machined quality components in one go. 

Each kit is specifically tailored to the bikes described in the listing title, if you are in any doubt please contact me to check before purchasing.

This pack contains:

Rear axle blocks complete with adjuster bolts (for the smaller 20mm rear axle found on the TE & FE enduro bikes only, NOT the TC, TX, FC or FX models)

Front brake, clutch & rear brake master cylinder reservoir caps (all Magura)

Steering stem bolt

Rim lock nuts

Valve caps

Addition advice for axle blocks:

The Apico Factory Racing Rear Axle Blocks provide the perfect adjustment for your rear wheel. CNC machined from aluminium, these laser-etched Axle Blocks are an ideal OEM replacement.

Laser-etched markings on each side of the block provide you with a sighting tool to make sure each side of the axle is lined up to the swing arm correctly.

These axle blocks come with a square nut that used to remove the fixed block from the axle.

To do this remove the rear axle from the bike & clamp the fixed axle block in a soft jawed vice or similar, then screw the nut onto the threaded end followed by the original axle nut, tighten these 2 nuts together to lock them to the axle, then turn the square nut anticlockwise to remove the axle from the fixed block, fit the new axle block by tightening it on the same way, I would recommend using a threadlock to secure it.

Please check the Compatability Chart for the exact models & years that this pack will fit, if you are in any doubt please send me a message through eBay