■How to Apply Decals

1. Cut out the logo from the backing paper to the required size using scissors or a craft knife.

2. Soak the cut-out logo in lukewarm water for about 10 to 20 seconds.

3. Move the logo along with the backing paper to the desired position, then shift the logo onto the desired spot.

4. Use a wet finger to slide it into the correct position.

5. Once in position, use a cotton swab to roll over it, pushing out any air bubbles and water from the center outwards to fix the logo in place.

　(Be careful not to press too hard, as this might cause the logo to move or peel off.)

6. Do not touch the applied decal until it has dried and adhered properly.

7. For overcoating with clear paint, after the decal has fully dried, spray a small amount and let it dry, then repeat this process several times.

　Be cautious not to apply too much clear coat at once as it might erode the decal and cause it to shrink, warp, or tear.