You are buying a slip yoke and stub shaft kit for 2.500" x 0.83" tubingĀ
3-3-2701KX:
General Design Type - LD-MD Driveshaft
U-Joint Series - 1350
Spline Major Diameter - 1,375
Spline Count - 15 visible 16 with missing spline
Spline Type - 15 Based on 16 Spline
Max Joint Angle - 45,000
Universal Joint Retaining Width (E) - 3,875
Universal Joint Bearing Diameter (D) - 1,188
Centreline of Joint to End of Spline (J) - 6,810
Centreline of Joint to Face of Plug (F) - 1,190
2-40-1711:
Spline - 1.375x16
Tube - 2.500 X .083
(K) - 6.344
(L) - 2.250
(R) - 5.625
(B) - 2.344
Compatible U-Joint kits
5-178X, 5-1350X
Style Snap Ring
Welcome to Mako Driveshafts LLC
We are excited to have you as our customers
Our business is built around finding solutions for our customers and we appreciate every one of you!
We are a proudly USA built company and we ship out of Fort Lauderdale, Florida
Whatever we have shown in stock is on the shelf and ready to ship
We offer same day shipping and if purchased before 1pm EST consider your order on the way!
Step 1
Establish what style of Universal Joint you are working with. This is important, since u-joints have a different way of measuring depending on the style of u-joint that you have. The way that you measure the u-joint will translate into how you measure the other components you may need. ALWAYS use a set of Vernier Calipers or Micrometers, tape measures will never produce accurate results! These are mechanical parts and require precision
After comparing the Type of U-Joint in Step 1)
Measure your u-joint in the correct manner and identify what series you have
Outside Snap Rings *Inside Snap Rings **Outside+Inside Snap Rings *** SPRTAB Style **** Bearing Plate *****
Light & Medium Vehicles
Outside Snap Rings *Inside Snap Rings **Outside+Inside Snap Rings *** SPRTAB Style **** Bearing Plate *****
Commercial Vehicles
There are two applications for slip yokes that determines what type of slip yoke you need
Please follow the steps
There are two types of splines
Midship stub shaft (For use with Carrier Bearings)
Center Bearing's are easy!
They are used to support two piece driveshafts & are identified as follows:
Identify your Flange
Weld in Tube Yokes