The AHGaming logitech magnetic shifter mod is a PLA+ print that features neodymium magnets giving you the right amount of feedback on quick shifts with a more prominent click to give a much improved feel over the standard Logitech shifter. Alot of sellers use standard PLA which is brittle and weak. Our PLA+ is stronger, more flexible, and more ductile.
Shifter comes with:
- 4x neodymium magnets (pre installed)
- 2x nuts
- 2x bolts
Note - a 2.5mm Hex key is required to tighten the 2 screws
Installation Instructions:
1. Align our mag shifter with the logitech shifter. As they are magnetic, they will snap into place
2. Move/Align our mag shifter so it's touching the face of the paddles on both sides evenly and insert the bolts and nuts
3. Gently tighten the bolts on both sides, but allow some slight wiggle room to micro adjust - top tip: rotating the wheel 90 degrees makes it easier (so the bolt/nut does not fall out)
4. Test the feel of the shifer paddles and adjust if needed - top tip: pull on the Logi paddle shifter to allow you to move our mag mod shifter slightly closer - whilst holding, tighten the screw - then release
5. Test the feel again and micro adjust.
6. Once happy with the position of the shifter - tighten the screws to lock into place. No need to overtighten.
If for any reason you are unhappy with the product, please contact us and I'll be happy to arrange a return. If you have any other queries, please get in touch!