all working, ive tightened the belt recently. got all the parts for desk mounting the wheel and the original paddle shifters that came with the original wheel. handbrake made by myself. its not perfect as the 3d printer wasn't very good but it does the job. it uses a guitar potentiometer connected to an Arduino pro micro. well looked after just a bit dusty as i havent used it in a while so its better off going to someone that will use it as i prefer flight simulators now. i would accept trades for flight sim equipment if you are near Edinburgh or meet me halfway. i can post but it will be expensive (included in cost since ebay thinks more than £9.50 for postage is too much) and not as quick as the postage on ebay says but i will keep you informed.