Note: 

Please send us immidiately Rider Name & Number after the purchase.


Instructions For Fitting:

  1. Clean the Surface: Wash the area where you plan to apply the decal. Make sure it's free of dirt, debris, and wax. Use a mild detergent and water, and dry the area thoroughly  DO NOT WAX your PWC before applying this kit.

  2. Measure and Positioning: Measure the area where you want to place the decal. Use masking tape or a removable marker to outline the space or mark the position.


  1. Prepare the Decal: If the decal is large, you might need assistance. Carefully unroll or unfold the decal, ensuring it doesn't stick to itself. Trim any excess material if necessary.


  1. Apply Decal with Water or Adhesive: Depending on the type of decal, you may need to use soup water, water or an adhesive.Spraying the surface or the adhesive side of the decal with a mixture of water and soap to facilitate easier positioning and removal of air bubbles.

  2. Smooth Out Air Bubbles: Use a squeegee or a soft, flat tool to smooth out the decal from the center toward the edges. This helps remove any air bubbles trapped underneath.

  3. Final Inspection: Step back and check the decal for any bubbles, wrinkles, or misalignment. If necessary, use a needle or pin to poke small air bubbles and smooth them out. 


  1. Finishing Touches: If there are any edges that aren't fully adhering, you can use a heat gun or hairdryer on a low setting to gently warm the decal, which can help it conform better to the vehicle's contours.The amount of heat gun no more than 25%. Keep strict note on that.

  2. Allow to Cure: Give the decal some time to adhere properly to the surface. Avoid washing the area or exposing it to extreme conditions for at least 48 hours.


Shipping: 


Warrenty: 


Return: 


                      

THANK YOU..!