Remove dents from your 2 stroke pipe using your air compressor and a heat source. Contains parts to seal off both ends of the pipe, including an air valve on one end. Dents can be removed by applying air pressure and gently heating the damaged area. The increase in air pressure in the pipe pushes the dent outwards.
Built-in 100 psi pressure gauge to monitor the pressure inside the pipe during dent removal offering additional safety. Lesser tools don't have these.
Pipe can be heated with mapp gas or propane torch but oxy/acetylene is preferred.
FITMENT NOTES: Universal fit on header end for modern pipes. Measure your pipe prior to ordering and/or include the bike year, make and cc size in notes to seller upon purchase. This way I can make sure you receive the correct size for your application.
1) This kit will not fit the rare FMF "SST" pipe. The stinger end on the SST pipe has a larger diameter and must be milled on a custom order. Please send a message to seller.
2) The YZ250X has a NOTCH in the muffler end of the pipe. YOU will have to determine the best way to seal off the end. Some users cut the end of the pipe to eliminate the notch. This is just a heads up so you are aware of the issue with the YZ250X pipe (the YZ250 pipe is FINE). We have no way to seal the notch with our tool; therefore this tool will not work unless you determine a way to eliminate air from escaping the notch.
There are also specific kits sized to fit KTM 65/85cc, CR500 and KX500cc pipes.
Simple to use. General usage instructions included. For more information and tutorials, enter "2-stroke dent repair" into your search engine.