These pads are hand cut, and may slightly differ in size (The original felts had a range of sizes!)

These labels have been made using the exact size of the originals, with the correct font. The labels are printed with a “mat vinyl” finish, and are a very good replacement for missing, wornout or loose original labels, that are now some 40 years old! I would advise writing on the labels before sticking them on, just because its easier!

To fit felt:

Gently tease out a loop of tape, so you can get to the old felt pad (or the metal mount) and remove the old felt with tweezers, then clean the strip with IPA on a Cotton bud until its clean.

Carefully remove the backing tape on the new pad, and place in the centre of the metal strip (I use Tweezers to mount them), once mounted, GENTLY push on the pad to make sure its properly stuck down. then using the edge of a pencil, or something soft - roll against the side roller and real in the tape loop. 

Now got test it!

Many MANY thousands of these felts have been sold and used without any problems, so please buy with confidence.

(I MAY be able to offer a "re-felting" service, please contact me if this interests you)

Any questions, please ask away

Check my other Microdrive auctions for the individual felts, face & spine labels!

I can supply these in much larger packs, please just ask.