Arduino Reed Sensor Module Magnetron Magnet Magnetic Switch Component MagSwitch

A handy magnetic reed switch module for your project. This module has been used in the following applications: PBX, photocopiers, washing machines, refrigerators, cameras, door, window magnetic, electromagnetic relays, electronic weighing, level meter, gas meter, water meter etc

Module Detail

1 x Arduino Reed Module

Operating Voltage: 3.3V-5V

Output format: digital switching outputs (0 and 1)

Fixed bolt holes for easy installation

Approximate PCB Board Dimensions

Length: 32mm

Width: 14mm

Thickness: 7mm

Use a wide voltage LM393 comparator

Imported normally open reed

The comparator output signal is clean, good waveform, driving ability, more than 15mA.

A few words to assist your buying experience

Welcome and thank you for visiting! My brief policies are below and are aimed at helping a clear and efficient buying process for you:

Postage

I will be happy to combine postage to help reduce costs for items purchased in my store. I will post all items from within Australia and following full payment I will typically post within 24 hours.

You may choose Standard, Registered or Express Post when completing checkout.

Payment

I accept PayPal and Bank Transfer for payment. Please let me know if you will be using bank transfer, so that I can look out for the funds.

To assist a speedy delivery, I would appreciate prompt payment. However, if you are expecting to delay your payment please let me know, as communication is helpful.

Delivery Issues

If you any have issues with your delivery, please do not provide neutral or negative feedback – please contact me directly. By communicating, we’ll find an agreeable solution to any problem.