Please read the following important notice before purchasing.

  • For international shipments, buyers will pay import charges (Brokerage fees, duties and taxes if occurred).
  • Tracking number or shipment notification will be sent to your eBay registered Email box within 24 hours (excluding weekends, holiday). If you do not receive the email notice, please contact us ASAP.
  • Shipping time depends on the shipping method the buyer chooses; it is out of our control. We can’t be of any help on shipment delay, please use our shipment notification and check with carrier’s website.
  • We are not responsible for any damage that may occur during the application of the patch on wears. Please be careful while putting the patches on. If there are any questions about the application process, please contact us for the instruction.

The listing is for 45 pieces same design Iron On Rhinestuds Hot Fix Motif Applique (picture only show 4 pieces).  

In stock, ready for shipping!!


Instructions to Apply Iron on Transfer:

1. Set iron to cotton setting with no steam

2. Carefully remove transfer from cardboard packaging.

3. Peel off textured backing from the design (studs should stick to the clear plastic sheet). If any studs have shifted out of place, put them back in place using tweezers.

4. Place plastic sheet, studs side down, on right side of fabric and press into place with hand. The clear plastic sheet should stick to the fabric.

5. Cover patch with a thin cloth or wax paper.

6. Press straight down for approx 15~20 seconds; use pressure only, no back & forth motion.

7. Set aside and allow fully cooling down for 15 to 20 minutes or longer if needed.

8. Slowly and carefully peel the clear plastic sheet away from the fabric. If all studs are not sticking, you may re-iron on the opposite side of the fabric again.

Be sure to check all garments to make sure fabric can tolerate the required heat.