Pulse 3, USB Glow Plug Ignition Unit

Pulse 3 is USB ignition unit for glow engines. The main feature is long ignition time with better efficiency and available USB power supply.

Features

Large capacity
Sometimes not enough capacity of one-cell (1.2 V) starter causes engine-starting failure at the flying field. Pulse 3 can be the solution 
because power source of Pulse 3 is 5V, 4.8V, 6V and 7.4V these batteries are general in power bank for smart phone (5V)
and receiver battery packs (4.8V, 6V, 7.4V). Their high voltage and large capacity provide long ignition time.        

Pulse Ignition
Pulse 3 takes pulse ignition. The efficiency is 50 % better than general glow starters. Also it prolongs total ignition time.
       
Receptacle for easy apply
It is hard to plug in glow starters to the engines for scale airplane (they have large cowls), helicopter and the engines installed upside down. 
Because Pulse 3 is connected by receptacle installed on fuselage, there is no difficult to start engines in any type of models. 
(One receptacle is included in this package.)

Notice: To prevent over heating the ignition time is limited within 5 minutes at once.

Contents
Pulse 3 unit1 pcs (The power bank is not included) 
Receptacle 1 pack (with Alligator clip 1 pcs, U-spring plug wire, Plastic washer 2 pcs, Nut 1 pcs)

Specification  
Input Voltage
Output Voltage		5 V 
1.5 V
Current drain 4 mA (Standby), 1.3 ~ 1.5 A (Ignition)
Size 83 X 28 X 19 mm, 400mm (cable)
Weight 40 g
  
Installation (How the plug cap attaches the glow plug)

Slightly pressing the cap, rotate (circle likes) clockwise till stop in.

For detaching, Slightly pulling the cap, rotate count clockwise.

Notice : Do not pull out without rotating. Otherwise the inner spring is pulled out.