S.H.G Marine Propeller Shaft Assembly
Stainless Steel Propeller Shaft assembly with Brass Outer Tube
M4 Diameter Shafts
An excellent range of
general-purpose shaft and tube assemblies with Grade 303 Stainless Shafts and
Hard Grade Brass outer Tubes.The outer tube diameter is 8mm, Shaft Diameter 4mm.
The
Bearings are Oil / Water lubricated Acetyl material and are extremely hard
wearing and Quiet.
The Shafts are Threaded at both ends with an M4 Thread
Shaft & Tube assemblies suitable for most Radio Control model boats, can be assembled into Wooden and Glass Fibre Hulls, also used in Plastic model kit conversion.The assembly should be packed with Bearing Grease after installation in the hull, this will give long life and the Grease should only require changing at the end of a season
No Oiler tube is required on these assemblies.
The S.H.G range of shaft assemblies are produced to the highest standards in the U.K.
©2016
S.H.G. Model Supplies. All rights reserved.