Charger for AMB TranX 160 Kart Transponder, 260 & MX Transponder NEW - 3D Printed Charges all AMB160, 260 & MX transponders, as shown in the photo. It does not work with any of the subscription transponders - Flex or X2 The internal electronics of the charging cradle are the same as the original AMB one. It DOES NOT include the transponder. The photo is for illustration. This is a not original AMB. Made, in the UK, by us at Kart Crazy, I am an Electronic Engineer. The power supply is UK three pin 240v. It does not support the "sleep" mode on the transponders with the black bottoms. About Kart Crazy; It was apparent to me the cost of kart electronics was high. So I started repairing transponders and designed sensors to work with MyChron & Alfano lap timers – Kart Crazy was born. Since then we have expanded our range to include 3D printed kart products & use the printer to make lap sensor cases. We try to be a “green” as possible. Our office/workshop is solar powered and we use PLA, which is a biodegradable plastic made from renewable natural resources. |