Gimbal Bearing Puller RemoverThis bearing puller remover can easily remove the gimbal bearings on bell housings by turning the end of the tool with a wrench. | Bearing Installer and Enigne Alignment ToolsUsed to install the new gimbal bearing back, set the bearing on the installer than insert the installer in engine. Also it can be used to check engine coupler alignment with the gimbal bearing and drive. | Hinge Pin ToolThis tool is for removing or installing the hinge pins on the port and starboard sides of Mercruiser Stern Drive bell housings. |
Premium Material
| Great Quality
| Convenient StorageThe tool set includes an eyebolt which gives you the option of hanging the tool. |
Step 1Plug in the remover to the bell housing. | Step 2Insert the blind hole puller into the remover, the puller will tightly lock bearing’s inner ring. | Step 3Turn the end of the tool with a wrench, you could easily pull the bearing out. | Step 4Pull out the tool, the gimbal bearing is pulled out too. DONE. |
Step 1Drill a hole in the alignment tool to install the universal bearing driver. | Step 2Install the bearing drive with the screw and place gimbal bearing upon the driver. | Step 3Push installer in, make sure the bearing is aligned. | Step 4Use a hammer to pound the installer head, ensure the gimbal bearing attach the bottom. |