Mini wood burners! Perfect for heating small spaces, (please note actual size in paragraph below, this is a unique model, please contact me if you require something larger) use in camper vans, camping sites, smoking fish or as a decorative feature in any home.

The body is made from 100 x 100 mm box section. The handle on the door is made from steel with a brass shell case over the top for decoration (this can be removed if you wish).

The burner It is 320mm tall to the top plate the top plate is 150mmx150mm

They are fitted with a short flu which is 48 mm external so a piece of 50 mm x 1 mm wall tube will be a tight fit over it or 51 mm x 1.5 mm.  Other 50mm pipe joiners can also be used.

A sleeve or 42mm tube can used as a joint to put another peace of 48x3 pipe on top of the current pipe the sleeve goes inside both to give a nice look and pro finish. 48x3 and 42 x3 is a very common sizes of pipe and is available at any local steel stock holder.

They are made from thick welded steel to make them very strong and durable (minimum thickness is 3mm unlike others that are only 1mm).

This is my top loading design so it can take a a lot of fuel for its size. Load from the top using a welding glove or oven glove. Pliers can be used to lift the lid as it will be very hot once the fire is lit. As you can see from the photos 2 pieces of wood can also be used.

The small door at the bottom of the unit is to light clean and regulate the air flow to the fire.

I used an Infra Red thermometer to test the temperature of this unit. As you can see from the photos it can go up to 321 degrees C before it then maxed out on the outer body of the unit. This was within only 10 minutes of lighting with pieces of split pallet wood. This unit does draw very well when dry wood is used. With a hard wood it would be higher temperature and with coal even higher I would estimate 500+

You can use a variety of fuels for example:
wood (dry)
wood chips (dry)
bbq charcoal
brickets
peat
coal *
*If you wish to use coal I would recommend fitting a small grill in the bottom to keep coal from directly touching the bottom as it will extend the life of the unit.


The safety bit:

Just a quick warning that fires get hot!
When this fire is installed it should be bolted down and made sure that it is safe before lighting . It should not be left unattended or in reach of children. Further information on fire safety can be found online. All burners have now been painted black with high temp paint. When the fire is first lit it will give off some paint fumes so must be well ventilated. I use a high quality ultra high temp paint unlike other similar burners on eBay. If this burner is installed in a confined space such as a van or boat a monoxide alarm should be fitted for safety.

These stoves are made as miniature stoves for hobbyists and not to be considered as safe or suitable to install in a house setting. The Stoves are all hand made and made to a very high specification however they are not certified by any organisation or company. They are designed for use out doors in a safe and controlled environment. We are unable to provide any advice or assistance regarding the installation or fitting of the stove.

These stoves are sold and used at the end users own risk. not for use in the home 

Fire Is Dangerous, Don't take risks!