Parameters:
Before you attempting to wire the protector, make sure power is off.
WARNING: DO NOT REVERSE POSITIVE AND NEGATIVE POWER LOADS.THIS WILL DAMAGE THE CONTROLLER.
1. Connect wires refer to the "wiring diagram" (NO. 9 picture).
2. Install the jumper to “Auto” or “Manual” modes. (Default is automatic mode.)
3. Set parameters of Current Limitation, Delay Time and Reset Time (automatic mode).
4. Turn on the power.
Current Limit Adjustment:
When the red alarm LED is lighting, eliminate the overcurrent factors, it will automatic reset (automatic mode), or push the Reset Button, reset the power (Manual Mode).
Reset the current limitation pot should as follow:
1. Turn off the power.
2. Adjust the Current Limitation pot until the desired maximum current is reached.
3. Reset the power.