Does your car have a diagnostic port that is difficult to access for bulky diagnostic tool modules?

Are you worried about wearing out the port by repeatedly connecting and disconnecting tools?

Do you just need an extra few inches of reach on the cable for your diagnostic tool?

If so, this may be the answer to your problems. You can plug this cable into the car's port and leave it in, connecting and disconnecting tools to the other end, protecting your car's port. It's small enough to be tucked out of sight on a lot of vehicles.

The cable has a standard OBD-II specification J1962 Female port on one end and a J1962 Male port on the other end, with all 16 pins electrically connected, so it can be used to extend the reach of any diagnostic tool that uses a standard J1962 OBD-II connector.