Clear Lens

Features and benefits:

·        Integrated LED Tail Lights with Signals （Bright2wheels INT） – An OEM-quality replacement our LED motorcycle tail lights produce a bright, easy-to-see LED color during braking and boasts built-in amber led turn signals

·        Maximum Quantity High-Brightness Led installed, Improves visibility and appearance

·        Quick and Easy Installation – Offering near plug-and-play use for both the red led running light and the brake light,our motorcycle tail lights offer a universal fit and come with connectors, resistors, and relays as necessary for a simple install.

·        Warranty: 6 months;

Our outstanding advantages:
•Free Shipping to domestic addresses
•We dispatch Our Order within 1 working day（Monday-Friday, Excl. holidays）

Installation of Built-in turn signals

(Optional: activate it only it will not conflict with laws in your country

please refer to below links for more details)

Connect the Yellow and blue wires to the positive turn signal wires using provided red connectors or

alternately use your existing factory connectors. Ground wire is not needed unless you are 

using resistors to slow down the blinking rate. The ground wire is the same color wire used on 

both turn signals.

To remove the error code on dashboard or slow down the blinking rate use our provided resistors or relay if necessary:

Wiring Diagram applicable to most bikes:

Black Wire(Negative),

Red Wire(Brake)

White Wire(Running Light)

1. Connect one end of the resistor to the ground wire on your turn signal harness from your bike.

2. Connect the other end of the resistor to both the YELLOW wire from our taillight and the positive 

turn signal wire from your turn signal harness from your bike.

3. Repeat the same process for the other side.

To use the red connectors, place one wire inside along one channel, place another wire inside along

the other channel. Push down the metal pin as it will make a small cut on each wire bridging the connectors.

if you are using the resistors, place one end of the resistor in the middle of either channel along with the one wire.