eBay

Product Description:

-The SPL-2000 2-channel stereo amp features on-board MP3 player which works via connection of a USB stick or mobile phone SD card with your music stored on there, and when connected to a pair of speakers it will play your music directly from either of those storage devices.
-Going completely wireless; the amp also has a built-in bluetooth receiver where you can stream your music directly. If you have a bluetooth device on your smart phone or laptop, you can send the music to the amplifier without any cables or wires.
-With RCA inputs at the back panel you can connect up the TV, CD player or laptop directly instead of using the wireless function, so no problem there. The amp is suitable for pub gigs, house party systems, small DJ venues and PA purposes. A quality, affordable multi-purpose amp for the busy DJ or home-end user.
Electromarket Cable Tie Included
-Main features include: Bluetooth 2-channel amplifier with equaliser and MP3, BT receiver for streaming audio from phones, tablets, PCs, etc, Switchable BT or line operations via RCA inputs, MP3 player with USB port and SD card slot, Drag MP3 files from a computer onto a USB stick and connect up to the amp to play immediately, Equaliser and FM tuner, Connect TV, CD players and computers/laptops directly, Red LED illuminated front panel, 3.5mm jack at the front for audio players

Specifications:

Size: 26 * 29 * 10cm
Rated voltage: 220V-240V 50 / 60Hz
Rated frequency: 20KH - 20KHz
Signal to noise ratio: 90dB
Standard impedance: 4 to 16 ohm
Type of power amplifier: AV power amplifier
Channel: 2.0 channel
Total harmonic distortion: ≤ 0.5%
Signal input sensitivity: 200mv (± 30mv)
Microphone input sensitivity: 9 mv (± 2mv)
Recording level output: 1V
Auxiliary level output: 1V
Support:USB Disk/Max 64GB SD Card(Not included)
Colour: Black

Features:
-Support 4 way microphone input
-LED Display
-2 tack output With EQ
-Reverberation, fine tuning, balance, SD, USB interface.

Packaged included:
1 x Audio Power Amplifier
1 x Remote control

Q & A:
1.There is sound from the audio cable connected to the amplifier, but the volume cannot be controlled. Why?
There are three groups of interfaces on the back of the amplifier: input is the audio input port, which is the two groups on the left; the third group of OUTPUT is the audio output port, which is the rightmost group.
The INPUT input port has two sets of cd end and dvd end. These two sets are used to connect external audio input signals. It is possible to connect the mobile phone headphone port / computer headphone port / TV.
2.Incorrect method
Many customers do not understand how to connect the third group of output ports, but cannot control the volume when there is sound. Because this interface is not an audio signal input port, it is an output port for connecting other power amplifiers or active speakers.
3.No sound
If there is no sound connected, it is because the mode position in front of your amplifier is not switched correctly.

There is a gear change knob -CD / DVD on the far right of the front of the amplifier, which corresponds to the rear CD / DVD interface: the rear gear is connected to the cd port and the gear is turned to the CD position.