This Repair Kit is directed to people with basic knowledge in electronics and tools such as a soldering iron, solder wick, and solder.

                     ( If you want to know more about installation you can search and watch youtube videos)

REPAIR TIME:

Should take under an hour.

M-tronicz  is offering this repair kit for a common failure in Vizio  M552i-B2  Power Supply Boards:

COMPLETELY DEAD TV

BLOWN IC901

These parts are failing in most of these tv sets due to 

the excess flow of current.

They can be bad and still look decent .

We're using same upgrade parts in our Repair Services.

 

You will receive parts from the same pool that our technicians on site use and only the parts

that commonly fail on these boards.

Many of these are recommended replacements on the official Service Manual to correct factory installed parts.

M-tronicz recommends to replace all parts at the same time even if they look ok. these

parts tend to fail in different ways.

***********************

 If you ordered the wrong part or ordered by mistake send me a message and I will handle the return process internally. 

Just wait for the return form sent via ebay messages.

 

<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>>> 

Be sure to check out my other items for sale.

<<<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>

NOTE

**********************************************************************

Because not all of the boards fail in the same way, we do not guarantee that the components in this kit

 is all you need to fix your board but it can take care  90% off all cases. 

It's your responsibility to troubleshoot and properly diagnose your board in order to complete the repair.

It is important to note that the above described behavior can be caused by a number of very different 

failures and not all of them could be related to this repair kit !

We recommend all kits fitted by a qualified personnel. 

A successful repair depends on the own skill and fault finding ability.

This service kit is intended for use by persons having electrical, electronic 

and mechanical experience and knowledge at level generally considered 

acceptable in the consumer electronics and appliance repair trade.

DOING YOUR OWN REPAIR WORK: The removal and replacement/installation of electronic components 

at the circuit board level is NOT recommended if you are not experienced with electronic 

component and circuit board repair. If you are new to this stuff, please take our advice 

and leave the work to a qualified expert- you will most likely thank yourself later. 

It is VERY easy to cause damage to electrical parts and circuit boards 

if repairs are not done with precision, neatness, and accuracy. It is very easy for 

one to make problems WORSE than they were before, if one does not know what one is doing, 

or does not have adequate experience with these kinds of parts and this kind of work in general.