THE TRACING PAPER IS USED TO PROTECT THE CARBON GOING ONTO STENCIL PAPER
IT CAN BE USED TO TRACE BUT NEED TO USE CORRECT PEN/PENCIL AS ITS VERY FINE
- TEST CHOSEN PEN TO FIND OUT IF IT WORKS
BASIC GUIDE
CREATING STENCIL
REMOVE PROTECTIVE LAYER
PRESS PEN ON TOP WHITE SHEET ONTO CARBON SHEET (BLUE SHEET)
WHAT YOU PRESS DOWN WILL MARK BOTTOM OF TOP SHEET WITH THE CARBON
THIS WILL BECOME YOUR STENCIL
YOU CAN TRACE OVER PRINTED IMAGES OR FREE HAND DESIGNS
SIMPLE APPLICATION INSTRUCTIONS
MAKE SURE AREA IS CLEAN, APPLY FLUID, IT THEN NEEDS TO DRY A BIT
NEEDS TO BE JUST RIGHT - NOT TO WET AND NOT TO DRY
THEN APPLY TRANSFER GENTLY AND PRESS DOWN FIRMLY FOR MINIMUM 30 SECS
THEN GENTLY PEEL OFF AND ALLOW TO DRY IF IN CORRECT POSITION
IF NOT CLEAN OFF ASAP AND REPEAT UNTIL IN CORRECT POSITION
IT CAN TAKE A LITTLE PRACTICE TO MASTER, SO TRY SOMETHING SMALL AND GET USED TO IT FIRST
BEFORE MOVING ON TO BIGGER PIECES