ADHESIVE WITH A NEEDLE 30ml by WAMOD
Modeling glue is intended for gluing polystyrene models and other objects made of this material
SPECIFICATION:
*Strongly bonds by dissolving the surface of plastics (cold welding). It dissolves the surfaces of dense polystyrene components, creating the possibility of a thin coating between the joined elements. During the evaporation of the solvent as a result of intermolecular reactions, a virtually unbreakable connection is formed.
*After drying, the glue remains transparent, crystal clear and odorless.
*The joint is resistant to cold and temperatures up to 90 degrees C. The adhesive is also resistant to water, petrol, diluted acids and alkalis.
*The glued surfaces must be clean, free of dust and grease.
*Strong adhesive for joining polystyrene plastics (for gluing plastic models).
HOW TO USE:
*Apply a thin layer of adhesive to one or both sides of porous or uneven surfaces.
*Put the glued parts together, press and hold. For surfaces that are difficult to stick together, leave the applied glue to dry for 3-4 minutes, then apply it again to one side, put the glued parts together, press and hold.
*When gluing thin materials, apply a very thin layer of glue.
*Do not wipe off wet adhesive residue.
INCLUDED:
Convenient cleaning wire.
Glue with a needle 30ml by Wamod