5x7 “H- Bar” Aeroponic / Hydroponic

Manifold for Cloning & Net Pot Wetting

10 red 360 Degree Sprayers

Build your own Cloning Bucket

Consists of:

1 x 5x7 inch “H” Bar with 10, 360 degree spray heads (12 included)

1 x 8 inch riser (can be cut for best size fit)

1 ½ inch male hose connector with tubing

Manifold is ½ inch CPVC and all sections are glued except where the riser pops into the “T”. You can glue it in place or leave it as a blow out point if the sprayers get jammed. This will take pressure off the pump and keep it from failing. Based on a riser height of 8 inches or below a 150 GPH pump should work. The ½ hose connector segment allows for attaching to the pump, by hose.

Using a 150 gph pump the spray area can be up to 40 x 30 inches in coverage. This can be seen in the UV/fluorescent test picture.

What you do:

Gently screw in the spray heads. Don't over tighten and snap them off.

Select your riser height or keep it as is.

Insert the riser into the “H”.

Connect the manifold to the pump with the ½ inch hose connector end of the riser.

Pump not included.