These speaker covers replace the metal mesh circles covering your door speakers. Just remove the old OEM rusted / dented ones and pop these into place (no hardware required).

- 3D printed out of high strength PETG plastic they will never rust or dent like the OEM metal ones.

- No hardware required for install.

- Several designs available in my other listings.

- Easily paintable.

- FAST and FREE shipping from the USA.

- Made in the USA.

Please note: Only the center rings are included in this listing (not the OEM plastic surrounding the circular speaker covers)

Installation instructions:

1. Remove the whole plastic speaker cover shown in picture five. This plastic piece pops out with four plastic fasteners in each corner no tools are required.

2. Remove the metal speaker cover from the plastic surround, If you want to leave the OEM fabric be careful not to rip it. (Your new speaker covers can be installed with or without this fabric)

3. Make sure the new speaker cover is oriented properly (The 3 clips on the back will only work in one position) Now carefully insert the new speaker cover into the front of the plastic surround and press where each clip is sliding it into its corresponding hole. It will clip in and you are done.

4. Take the whole OEM plastics around with your new speaker covers installed in them and pop them back into your door.