10803 switching decoder with 8 relays for switching any consumers

• The decoder has 8 outputs that work as changers.
• Potential-free switching is possible through the use of relays, the consumer is completely separated from the decoder.
• It can be operated with DCC or Märklin Motorola.
• 100% quality check of all decoders
  Development and production in Germany
  We only use components from well-known brand manufacturers

tension

• Build up
  • 12-24V DC voltage
  • 9-18V AC voltage
  • 12-24V track voltage
  Inexpensive plug-in power supplies can be used. The decoder can also be powered directly by the track voltage.
• perfomance
  • 30V DC voltage
  • 30V AC voltage
  • 3A per relay
  Each relay can be loaded with 3A and is suitable for up to 30V DC or AC voltage.
• Requirement
  • Quiescent current below 10mA
  The decoder itself requires less than 10mA when idle. When all relays are switched, the power requirement is approx. 160mA. We recommend a power pack with at least 200mA.

hitching

• Artificial intelligence A little anyway. The decoder has an automatic learning mode for addressing. All you have to do is press a button and call up the desired addresses at your headquarters. Finished.
• Individually An individual address can be assigned to each output. The addresses are freely selectable.
• Social An address can be assigned more than once. When the address is called up, all outputs assigned to this address are switched.
• Remote control The decoder can be configured directly at its place of use from a DCC center using Programming-on-Main. All CV's can be updated.
• inspection The decoder can be configured on a DCC programming track. All CV's can be written in direct mode.

configuration

• Forever Each output can be configured as continuous operation. The selected relay is switched until it is deactivated by selection.
• memory When starting, the decoder automatically restores the last switching of the relay.
• Small steps You can set the switching duration individually. Switching times from 1 second to 255 seconds are possible. And that in small steps of one second.
• Individually The switching times can be configured individually for each output.

installation

• connections Phoenix Contact brand terminals for cables up to 1mm2.
• turntable The DCC or Märklin Motorola control signal is connected via optocouplers and is therefore completely galvanically isolated.
• Dimensions 120x60mm, 25mm high
• attachment 4 M3 size mounting holes. The inner diameter is 3.5mm.