40802 points decoder for controlling 8 points with motor drives

• The decoder has 8 outputs.
• It can be operated with DCC or Märklin Motorola.
• The decoder is suitable for turnouts with a motor drive or for turnouts with polarized DC drives.
• 100% quality check of all decoders
  Development and production in Germany
  We only use components from well-known brand manufacturers

tension

• Build up
  • 9-24V DC voltage
  • 9-18V AC voltage
  • 9-24V track voltage
  Inexpensive plug-in power supplies can be used. The decoder can also be powered directly by the track voltage.
• Performance
  • 9-24V DC voltage
  • 2A per output
  Each output can be loaded with 2A and supplies 9-24V DC. The decoder can be loaded with a maximum of 2A.
• Requirement
  • Quiescent current below 10mA
  The decoder itself requires less than 10mA when idle. The power requirements of the outputs depend on the connected item. We recommend a 2A power supply.
• Short conclusion The decoders are protected against short circuits with a self-resetting fuse.
• Long stop The decoders have a charge control so that the control panel does not incorrectly diagnose a short circuit when starting.

hitching

• Artificial intelligence A little anyway. The decoder has an automatic learning mode for addressing. All you have to do is press a button and call up the desired addresses at your headquarters. Finished.
• Individually An individual address can be assigned to each output. The addresses are freely selectable.
• Social An address can be assigned more than once. When the address is called up, all outputs assigned to this address are switched.
• Remote control The decoder can be configured directly at its place of use from a DCC center using Programming-on-Main. All CV's can be updated.
• inspection The decoder can be configured on a DCC programming track. All CV's can be read and written via direct mode.

configuration

• default By default, each output generates a switching pulse of 4 seconds.
• Small steps You can set the switching pulse individually. Switching pulses from 100ms to 25 seconds are possible. And that in small steps of 100ms.
• Individually The switching times can be configured individually for each output.
• Forever Each output can be configured as continuous operation. The selected port of an output is powered until the other port is activated.

installation

• connections Phoenix Contact brand terminals for cables up to 1mm2.
• Turntable The DCC or Märklin Motorola control signal is connected via optocouplers and is therefore completely galvanically isolated.
• Dimensions 90x50mm, 25mm high
• attachment 4 M3 size mounting holes. The inner diameter is 3.5mm.