Used in good condition.
The DI-100U Digital Load Cell Interface modules provide a simple, convenient method to connect resistive bridge type load cells to a PC or Raspberry Pi via USB or to connect the load cells to an Arduino via UART or Serial TTL Protocol. The DI-100U with a 16 bit ADC, is a good low cost, moderate accuracy (+/- 0.1% of full scale) alternative to our DI-1000U, 24 bit high accuracy digital load cell interface that can support +/- 0.02% accuracies of full scale enough to meet NTEP standards. The DI-100U comes with a Serial to USB dongle which converts the base UART signal into a USB output. The HX-100 adapter provides easy access to the Tx, Rx pins of UART without chopping off the miniB connector of your output cable.