Specification:

• Brand New Oxygen Sensor
• Quality Guaranteed Tested to Meet OE Specifications
• Line length:300mm 
• Placement on Vehicle: Upstream Oxygen sensor
• 5 wire configuration
• Direct Plug-In Replacement.
• Built and tested to strict quality control standards
•  Package Include  1pcs x Oxygen Sensor
  
• Warranty:  3 year 

Note:

Please make sure the interchange part number matches the part you are replacing.

Please check our photos and make sure the part shown looks identical to your stock one.

Fit Vehicles:

Acura

• MDX 2003-2006 3.5L V6
• RL 2005-2008 3.5L V6
• TL 2004-2008 3.2L V6
• TL 2007-2008 3.5L V6

Honda

• Accord 2003-2007 3.0L V6
• Odyssey 2005-2006 3.5L V6
• Pilot 2005-2008 3.5L V6
• Ridgeline 2006-2008 3.5L V6

Saturn

• Vue 2004-2007 3.5L V6

How to install the oxygen sensor?

Step 1 - Some sensors are equipped with a heat shield that must be removed before the sensor removal, this is performed by removing any mounting bolts.

 

Step 2 - By using a regular socket it minimizes potential damage to the sensor body and the threads, this technique helps avoid stripping the old sensor upon removal.

 

Step 3 - Then, locate and disconnect the wiring connector, this step should be done before removing the sensor if the wiring is still attached.

 

Step 4 - Its important that the wiring harness connectors are exactly the same, each sensor is unique to it's position and is located in the system by its connector configuration. (Note: some replacement sensors have a universal electrical connector that must be configured to the wiring of the old sensor.)

 

Step 5 - Use a small wire brush to help clean the threaded port to ensure a proper seal of the new sensor. Gently install the new oxygen sensor by hand while keeping the wiring and connector free from bends.

 

Step 6 - Gently tighten the sensor while keeping wiring free from damage, these sensors need to be fairly snug to avoid leakage.

 

Step 7 - Once the sensor is tightened, reinstall any heat shields or bracing that had to be removed.

 

Step 8 - After the heat shield has been reinstalled, mount the connector to it's holder and reattach the connector back onto the wiring harness. If the car has diagnostic trouble codes, they will need to be cleared.

Must know before buying:

1. If you have any problem, you can contact customer service online at any time. We will reply and try to solve the problem for you within 24 hours.

2. If the purchase is wrong, please contact us first. We will return the product or help you find the right product for replacement according to the actual situation!

(the price, quality and function of the oxygen sensor are fully included in our warranty and return policy. However, any labor costs, dealer store costs or damage caused by incorrect installation are not included.)

How do I know the O2 sensor is good or not? 
A: The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation.

Use a 10-mega ohm digital voltmeter. Hook up the voltmeter's red probe to the sensor's signal wire and the black probe to engine ground. (Use back probe method, DO NOT pierce the wire.) For a good sensor, voltage should fluctuate constantly between 0.1 and 0.9 volts after starting the engine for 2 or 3 minutes.

• Goes above range between 0.1 and 0.9 volt
• Remains below 0.5 volts
• Stays fixed at a particular voltage

You're free to choose replacement or refund if our sensor fails to work, in this case.