1pc L50 500W 8Ohm Full Bridge Mono Amplifier Board + Aluminum Heatsink
Feature:
Support mon0 500-1000W 8ohm full bridge amplifier.
The maximum output voltage + -100V sine wave
It uses FET HEXFET output in parallel, so its current output capacity is especially large,
It can work at 1000W 4 ohm. The requires a channel at least 3KG above the cooler and AC36-0-36 1200VA transformer.
Parameters:
Output power: 500W 8R 1000W 4R mono, supply voltage + - 50V DC, plus AC12-0-12.
400W 8R, 800W 4R mono, supply voltage + -45V DC, plus AC12-0-12.
300W 8R, 600W 4R mono, supply voltage + -38V DC, plus AC12-0-12.
Voltage gain: 200
Input sensitivity: 0.5V, output + -100V.
Noise value <25MV
Distortion <0.02% 1k hz, 500w, 8 ohm.
Maximum output current> 20A.
Amplifier efficiency> 60%, efficiency as half-bridge amplifier 10%.
Protection circuit working condition: boot delay of about 3 seconds, then LED flashing.
No DC output detection is normal, the relay connected, this time the LED is always bright,
When an error occurs in use, the relay is disconnected and the LED flashes.
Package:
1pc L50 500W 8Ohm Full Bridge Mono Amplifier Board+Aluminum Heatsink