These will not ship until around July 18th due to a delay at the heat treater.

Bundle & save!!!

Includes....

(1) Crankshaft pulley removal tool (reference MD998754/MB990767-01)

(1) set of camshaft gear locks to prevent movement of camshafts/alignment marks.

(1) timing belt tensioner pulley tool (MD998767   old # MD998752)

Don't miss out on these essential tools to do a timing belt change on your 3000GT / Stealth!  Save time and headaches, do the job right!  

These tools are proudly made in the USA!

timing belt tensioner pulley tool....

Tool accepts a 1/4" drive wrench or torque wrench.

Constructed of steel with pressed hardened pins for durability.

A torque wrench should always be used, but the tension can be adjusted by feel & double checked by the grenade pin (see your service manual).

This tool makes a timing belt change much easier.   You simply plug the tool into the  tensioner pulley, insert a 1/4" drive wrench, and turn in order to apply the correct amount of tension to the timing belt.  

crankshaft pulley removal tool....

This tool is made from hardened steel, with high grade pins/bolts.

Simply plug in a 1/2" drive wrench or breaker bar, which can then be held or lay against the axle or lower control arm, then use either a socket or 1/2" wrench/breaker bar to turn the bolt. 

gear locks....

There is an amount of tension from the lobes/springs that forces the gears to rotate, making it very difficult to keep the timing marks lined up.  Use these to keep your camshaft gears from rotating while you install the timing belt.  Made from 6061 aluminum, these will not damage your gears.  They also have a hole for hanging while not in use.

The last two images in the picture gallery show the tool dimensions.  Please use them to double check against your pulley to make sure they will work.

Feel free to message me with any questions!