The Super Blue Stepper Motor Electrical Rev Counter / Tacho Gauge (With Warning) is very impressive, when the ignition is switched off the gauge face is totally black and when the ignition is switched on the gauge does an automatic calibration sequence and the gauge face comes to life with an illuminated super blue detail, illuminated red needle and red warning LED that is all surrounded by a silver bezel. Upon shut down the gauge performs a red closing sequence to check the in built warning system. The Warning Level on this gauges is preset so there are no complications and fitting is plug and play due to the plugged looms etc supplied with the kit. For Multiple gauge installations these gauges plug directly into each other with the plugged looms supplied so no additional wiring is required!

This gauge represents the very latest Stepper Motor technology by performing a full self calibration sequence each time the ignition is turned on. As the ignition is turned on the gauge takes an automatic adjustment reading within the sensor to zero the needle compensating for the correct atmospheric pressure etc, resulting in 100% accurate readings regardless of elevation or climate. This gauges uses microprocessors / Swiss Movement to provide super smooth pointer movement for high precision readings under extreme conditions. This gauge also features a fantastic warning system with red LED warning light.

This extremely impressive professional gauge is absolutely packed full of features offering stunning looks and extreme precision within a very compact 30mm body

This gauge is supplied in a presentation box as a complete full kit with instructions, shallow mounting pod, sensor, plugged looms and fixings.

Please Read Bottom Paragraph Below & Understand Prior To Purchase: 

Gauge Features:

• Super Blue Illumination
• Illuminated Red Needle
• Smoked Black Lens
• Latest Swiss Stepper Motor Movement
• Start Up Calibration Mode
• Closing Warning Check Sequence
• Preset Warning LED (Above 6,000rpm)
• 2” / 52mm Diameter
• Shallow 30mm Gauge Body
• 270 Degree Sweep
• Latest Technology 
• Full Fitting Kit With Instructions (Including Mounting Pod & Plugged Looms)

Unlike other gauges Rev Counters require a signal supplied by the vehicle and not by their own independent sensors (as generally included with other versions of gauge). Due to the nature/requirement for signal we have no control over compatibility or signal issues.

For this reason ALL Rev Counters are bench tested prior to despatch so that we can guarantee 100% that the gauge is free from any operation defect in the event of an installation issue.

Modern ECU outputs for RPM are generally problem free, but if you intend or require connection direct to an ignition coil etc on older vehicles then you MUST make sure prior to purchase that the connection you are choosing is compatible with current rev counter installation.

As above all Rev Counters are fully tested prior to despatch and we can’t be responsible for specific vehicle connections/signals, so these are a non returnable item in the event of an installation / signal issue.

Please read and understand above fully prior to purchase. This in no way affects your standard 12 month warranty.