Item Features:
Indoor Infrared detection alarm
Use this wireless remote control motion sensor alarm to protect and prevent intruders in your home and office.
Very suitable for use in garages and sheds.
Wireless, infrared detector, motion activation.
Including 2 direct infrared remote controls.
Adjustable installation unit for easy installation.
Over 105 dB loudness, 110-degree wide angle.

Item Specifications:
Type: Alarm sensor
Material: Plastic
Color: White
Power supply: 4 AA batteries (not included)
Remote control power supply: CR2032 3V battery (included)
PIR motion sensor: built-in
Applicable to: front door, rear door, garage, car shed, and ancillary buildings
Scanning area: 110 °
Remote control range: 5 M
Detection range: approximately 7-10 meters.

Installation Requirements:
Due to the fact that the remote infrared warning device has the highest infrared detection sensitivity when the human body moves horizontally relative to the lens, while the longitudinal motion sensitivity is poor, attention should be paid to the angle and height of the detector's horizontal plane during installation, which has a significant impact on the protective area.
During installation, it is necessary to avoid infrared warning devices being close to cold and heat sources, such as hot and cold air vents, air conditioning vents, electric heaters, and cold air fans, and avoid facing the door directly.
The remote infrared warning device should be able to directly view the protected area without obstacles.
The remote infrared warning device should be at an angle of 10 to 30 degrees with the wall, at which point the detection distance is the farthest. The installation angle should be adjusted according to the actual situation during installation.

Installation method:
1. Fix the universal joint at a distance of about 2 meters from the ground.
2. Open the battery cover and install the 4 No. 7 batteries according to the markings inside the battery box.
3. Fix the remote infrared alarm on the universal seat, and rotate the infrared alarm to meet the installation requirements and detection needs.

Working method:
1. Install the battery. Press the remote control once, and the machine makes a 'beep' sound, while the green light is on. This represents that the alarm is ready to enter working mode.
2. The remote infrared alarm has a standby delay of 15 seconds when the green light is on and does not detect an alarm signal within 15 seconds. You must leave the detection area of the electronic dog within these 15 seconds.
3. If someone enters the detection area of the infrared alarm after 15 seconds, the red light will flash for 5 seconds. During this 5-second delay time, it is convenient for the owner to use the remote control to turn off the alarm. After 5 seconds, if no signal from the remote control is received, a harsh alarm sound will sound for 30 seconds, with an alarm volume of 105 DB. 15 seconds after the alarm sound ends, if someone touches the remote infrared alarm again, it will alarm again and repeat the cycle.
4. When the remote infrared alarm alarms, you can use the remote control to close the detection circuit and end the alarm.

Package Included:
1 * Sensor Motion PIR Wireless Warning Alarm Kit
2 * Remote Controller

Notes:
Other accessories demo in the picture is not included.
Due to manual measurement, please allow size differences of about 1-5mm.
Due to the light and screen setting difference, the item's color may be slightly different.